Toyota RAV4 (XA40) 2013-2018 Owners Manual: Adjusting the settings
- To adjust the fan speed, turn the fan speed control dial clockwise (increase) or counterclockwise (decrease).
Turning the dial to “0” turns off the fan.
- To adjust the temperature setting, turn the temperature control dial clockwise (warm) or counterclockwise (cool).
If 
is not pressed, the
system will blow ambient temperature air or
heated air.
- To select the air outlets, set the air outlet selector dial to the desired position.
The positions between the air outlet selections shown below can also be selected for more delicate adjustment.
Manual air conditioning
system
Air outlet selector dial
Fan speed control dial
Temperature control dial
Cooling and dehumidification
function on/off button
Outside/recirculated air mode
button
...
Defogging the windshield
Set the air outlet selector dial to
position.
Set the outside/recirculated air
mode button to outside air mode if
recirculated air mode is used.
Perform the following operations a ...
Other materials:
Removal
(2005/11-2006/01)
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Remove front axle hub nut (see page ah-6)
Disconnect front speed sensor lh (see page
bc-191) ...
Switch failure
Description
This dtc is output when the sliding roof drive gear (sliding roof ecu)
detects that the slide open or
tilt up switch in the overhead junction block is stuck for 30 seconds or more.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Read value of i ...
Shift solenoid "d" performance (shift solenoid valve s4)
System description
The ecm uses signals from the output shaft speed sensor and input speed
sensor to detect the actual
gear position (1st, 2nd, 3rd or o/d gear).
Then the ecm compares the actual gear with the shift schedule in the ecm memory
to detect mechanical
problems of the shift s ...
