Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Cylinder head

Installation
Install no. 2 Chain sub-assembly Set the crankshaft key in the left horizontal position. Turn the cutout of the drive shaft so that it faces upward. Align the yellow mark li ...

Components
...

Other materials:

Reassembly
Install sliding roof drive cable Using a screwdriver, slide the sliding roof drive cable sub-assemblies in the direction indicated by the arrow in the illustration to install them. Hint: Tape the screwdriver tip before use. Engage the 2 claws and install the sliding roof ...

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. When installing the moulding, heat the vehicle body and moulding using a heat light. Standard heating temperature Notice: Do not heat the vehicle body and moulding excessively ...

Reassembly
Install front oil pump oil seal Using sst and a hammer, install a new oil seal to the pump. Sst 09350-32014 (09351-32140) Hint: The seal end should be flat with the outer edge of the oil pump. Coat the lip of the oil seal with petroleum jelly. Install front oil pump bo ...

В© 2011-2026 Copyright www.trav4.net