Toyota RAV4 (XA40) 2013-2018 Service Manual: Dtc check / clear
Notice:
When the diagnosis system is changed from normal
mode to check mode or vice versa, all dtcs and freeze
frame data recorded in normal mode are erased. Before
changing modes, always check and make a note of any
dtcs and freeze frame data.
Hint:
- Dtcs which are stored in the ecm can be displayed on
the intelligent tester. The intelligent tester can display
current and pending dtcs.
- Some dtcs are not set if the ecm does not detect the
same malfunction again during a second consecutive
driving cycle. However, such malfunctions, detected on
only one occasion, are stored as pending dtcs.
- Check dtc (using intelligent tester)
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Select the following menu items: diagnosis /
enhanced obd ii / dtc info / current
codes or pending codes.
- Check the dtc(s) and freeze frame data, and then
write them down.
- Check the details of the dtc(s) (see page es-51).
- Clear dtc (using intelligent tester)
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Select the following menu items: diagnosis /
enhanced obd ii / dtc info / clear codes.
- Press the yes button.
- Clear dtc (without using intelligent tester)
- Perform either of the following operations.
- Disconnect the cable from the negative (-)
battery terminal for more than 1 minute.
- Remove the efi and etcs fuses from the
engine room relay block (located inside the
engine compartment) for more than 1 minute.
Description
When troubleshooting obd ii (on-board diagnostics)
vehicles, the intelligent tester (complying with sae
j1987) must be connected to the dlc3 (data link
connector 3) of the vehicle ...
Description
Freeze frame data records the engine conditions (fuel
system, calculated load, engine coolant temperature,
fuel trim, engine speed, vehicle speed, etc.) When a
malfunction is dete ...
Other materials:
Front brake
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Remove front wheel
Drain brake fluid
Notice:
Wash off brake fluid immediately if it comes in
contact with any painted surface.
Disconnec ...
Tires
Replace or rotate tires in accordance with maintenance schedules
and treadwear.
Checking tires
New tread
Treadwear indicator
Worn tread
The location of treadwear indicators
is shown by the ¢Â§twi¢¸ or ¢Â§ƒ´¢¸
marks, etc., Molded on the si ...
Check mode procedure
Description
Check mode has a higher sensitivity to malfunctions
and can detect malfunctions that normal mode
cannot detect. Check mode can also detect all the
malfunctions that normal mode can detect. In check
mode, dtcs are detected with 1 trip detection logic.
Check mode pro ...