Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Sfi system

Reassembly
Install piston Using a small screwdriver, install a new snap ring onto one end of the piston pin hole. Hint: Make sure that the end gap of the snap ring is not aligned with the pin ...

Precaution
Notice: Perform reset memory (at initialization) when replacing the automatic transmission assembly, engine assembly or ecm (see page ax-18). Perform registration (vin registration) when r ...

Other materials:

Installation (2005/11-2006/01)
Install no. 1 Roof silencer pad W/o sliding roof: Install the 5 silencer pads. W/ sliding roof: Install the 2 silencer pads. Install no. 3 Roof silencer pad Install no. 1 Roof wire Only when replacing the roof headlining: Align the marking, and then ...

Intake air temperature sensor gradient too high
Description The intake air temperature (iat) sensor, mounted on the mass air flow (maf) meter, monitors the iat. The iat sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the iat is low, the resistance of the thermist ...

Yaw rate and deceleration sensor
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove front seat assembly lh For manual seat: ...

В© 2011-2026 Copyright www.trav4.net