Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Readiness monitor drive pattern

Checking monitor status
Perform monitor drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch and the tester on. Clear the dtcs (see page es-35). Run the vehicle in accordance with ...

Purpose of readiness tests
The on-board diagnostic (obd ii) system is designed to monitor the performance of emission related components, and indicate any detected abnormalities with dtc (diagnostic trouble codes). Sin ...

Other materials:

Short in front driver side pretensioner squib circuit
Description The driver side front pretensioner squib circuit consists of the center airbag sensor and the front seat outer belt lh. This circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the front prete ...

Disassembly
Remove generator pulley with clutch Remove the cap from the pulley. Using a screwdriver, puncture the center of the cap and pry it off. Notice: Do not reuse the cap. Install sst to the pulley and vise as shown in the illustration. Sst 09820-63020 Mount sst (a) i ...

Pressure control solenoid "b" electrical (shift solenoid valve sl2)
Description Shifting from 1st to o/d is performed in combination with the on and off operation of the shift solenoid valves sl1 and sl2, which are controlled by the ecm. If an open or short circuit occurs in any of the shift solenoid valves, the ecm controls the remaining normal shift sol ...

В© 2011-2026 Copyright www.trav4.net