Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

Hint:

Toyota RAV4. Installation


  1. Install front door belt moulding assembly lh

  1. Attach the claws to install the belt moulding.

Hint:

Confirm that the moulding is firmly installed.

  1. Install outer rear view mirror assembly lh (see page mi-12)

  2. Install front door trim board subassembly lh (see page ed-33)

  3. Install front armrest base panel upper lh (see page ed-34)

  4. Install front door lower frame bracket garnish lh (see page ed-35)

  5. Connect cable to negative battery terminal

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Notice: Wait at least 90 sec ...

Rear door belt moulding
Components ...

Other materials:

Front seat cushion heater
Inspection Inspect front seat cushion heater assembly lh Measure the resistance of the seat cushion heater. Standard resistance If the result is not as specified, replace the seat cushion heater assembly. Heat the thermostat with a light. Measure the resistance of the sea ...

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor monitors (active air-fuel ratio control type)
Preconditions The monitor will not run unless: 2 Minutes or more have elapsed since the engine was started. The engine coolant temperature (ect) is 75°c (167°f) or more. Cumulative driving time at a vehicle speed of 48 km/h (30 mph) or more exceeds 6 minutes. Air-fuel rat ...

Audio settings
Settings are available for adjusting the radio operation, cover art, etc. Screen for audio settings Press the “setup� button. Select “audio� on the “setup� screen. Number of radio presets select the number of radio preset stations. Display cover art on/off Auto ...

© 2011-2026 Copyright www.trav4.net