Toyota RAV4 (XA40) 2013-2018 Service Manual: Vehicle speed sensor
Description
Refer to the sfi system (see page es-224).
Wiring diagram
Refer to the sfi system (see page es-224).
Inspection procedure
Refer to the sfi system (see page es-224).
Diagnostic trouble code chart
Hint:
If a trouble code is displayed during the dtc check, check
the trouble areas listed for that code in the table below and
proceed to the appropriate page.
...
Stop light switch circuit
Description
While driving with the cruise control, if the ecm detects that the brake
pedal is depressed, the cruise
control operation will be canceled. The stop light switch sends brake pedal ...
Other materials:
System description
Description
The eps (electronic power steering) system generates
torque through the operation of the motor and the
reduction gear installed on the column shaft in order to
assist steering effort.
The power steering ecu determines directions and the
amount of assisting power in accordanc ...
Installation
Install rear no. 1 Seat assembly lh (w/o rear no. 2 Seat)
Fully tilt the seatback forward.
Place the seat in the cabin.
Notice:
Be careful not to damage the vehicle body.
Connection procedures of seat to lock cable when
reusing seat:
Using a screwdriver, detach the cla ...
Dtc check / clear
Check dtc (using sst (check wire))
Check the dtcs (present trouble code).
Turn the ignition switch on, and wait for
approximately 60 seconds.
Using sst, connect terminals 13(tc) and 4(cg)
of the dlc3.
Sst 09843-18040
Notice:
Connect the terminals to the correct
positio ...
