Toyota RAV4 (XA40) 2013-2018 Owners Manual: Cup holders
Front
Rear
Pull the armrest down.
Adjusting the size of the cup holder (front passenger’s side)
The adjuster can be removed.
Caution
Items unsuitable for the cup holders
Do not place anything other than cups or aluminum cans in the cup holders.
Other items may be thrown out of the holders in the event of an accident or sudden braking, causing injury. If possible, cover hot drinks to prevent burns.
Console box
Lift the lid while pulling up the
lever to release the lock.
When using the console box lid as an armrest (vehicles with slide
function)
Slide the console box lid forward as
needed. Pull the ...
Bottle holders
Front
Rear
Caution
Items unsuitable for the bottle holder
Do not place anything other than a bottle in the bottle holders.
Other items may be thrown out of the holders in the event of a ...
Other materials:
Disassembly
Remove generator pulley with clutch
Remove the cap from the pulley.
Using a screwdriver, puncture the center of the
cap and pry it off.
Notice:
Do not reuse the cap.
Install sst to the pulley and vise as shown in the
illustration.
Sst 09820-63020
Mount sst (a) i ...
Reassembly (2005/11-2006/01)
Install drive shaft bearing case subassembly
Using sst and a press, press in the drive shaft
bearing case to the inboard joint rh.
Sst 09527-10011, 09710-04081
Notice:
The bearing should be installed completely.
Using a snap ring expander, install a new drive shaft
hole ...
Map light assembly
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove map light assembly
Detach the 4 cli ...
