Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Driving tips

The rear cross traffic alert function detection areas
The areas that vehicles can be detected in are outlined below. To give the driver a more consistent time to react, the buzzer can alert for faster vehicles from farther away. Example: The rea ...

Winter driving tips
Carry out the necessary preparations and inspections before driving the vehicle in winter. Always drive the vehicle in a manner appropriate to the prevailing weather conditions. Preparation for win ...

Other materials:

Emission control system
Parts location System diagram On-vehicle inspection Check fuel cut rpm Increase the engine speed to at least 3,500 rpm. Use a sound scope to check for injector operating noise. Check that the operating sounds stop momentarily and then resume when the t ...

Catalyst monitor (active air-fuel ratio control type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine and warm it up. Drive the vehicle at be ...

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove front seat assembly lh Remove the front seat. For manual sea ...

В© 2011-2026 Copyright www.trav4.net