Toyota RAV4 (XA40) 2013-2018 Owners Manual: Driving
- Before driving
- Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Automatic transmission
- Turn signal lever
- Parking brake
- Horn
- Operating the lights and wipers
- Headlight switch
- Automatic high beam
- Fog light switch
- Windshield wipers and washer
- Rear window wiper and washer
- Refueling
- Using the driving support systems
- Cruise control
- Lda (lane departure alert)
- Intuitive parking assist
- Rear view monitor system
- All-wheel drive lock switch (awd models)
- Driving assist systems
- Bsm (blind spot monitor)
- Driving tips
Tilting up and down
Tilts the moon roof up*
Tilts the moon roof down*
*: Lightly press either end of the
moon roof switch to stop the moon
roof partway.
The moon roof can be operated when
Vehicles with ...
Before driving
...
Other materials:
Brake switch "A" / "B" correlation
Description
The stop light switch is a duplex system that transmits two signals: stp and
st1-. These two signals are
used by the ecm to monitor whether or not the brake system is working properly.
If the signals, which
indicate the brake pedal is being depressed and released, are detected ...
Communication malfunction no. 1
Description
This dtc is output when a communication error occurs between the transponder
key amplifier and
transponder key ecu. Some possible reasons for the communication error are: 1) 2
or more ignition keys
are positioned too close together, or 2) noise is occurring in the communicatio ...
Reassembly (2005/11-2006/01)
Install drive shaft bearing case subassembly
Using sst and a press, press in the drive shaft
bearing case to the inboard joint rh.
Sst 09527-10011, 09710-04081
Notice:
The bearing should be installed completely.
Using a snap ring expander, install a new drive shaft
hole ...
