Toyota RAV4 (XA40) 2013-2018 Owners Manual: Automatic high beam
The automatic high beam uses an in-vehicle camera sensor to assess the brightness of streetlights, the lights of oncoming and preceding vehicles, etc., And automatically turns high beam on or off as necessary.
- Activating the automatic high beam system
- High beam automatic turning on or off conditions
- Turning the high beam on/off manually
Turning on the high beam headlights
With the headlights on, push
the lever away from you to turn
on the high beams.
Pull the lever toward you to the
center position to turn the high
beams off.
Pull the lever toward you ...
Activating the automatic high beam system
Push the lever away from you with
the headlight switch in position.
The automatic high beam indicator
will come on when the headlights
are turned on automatically
to indicate that the system i ...
Other materials:
General maintenance (2005/11-2006/01)
Inspect steering linkage and gear housing
Check the steering wheel free play.
Check the steering linkage for looseness or
damage.
Check that the tie rod ends do not have
excessive play
Check that the dust seals and boots are not
damaged.
Check that the boot clamps are not ...
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the rh side.
Remove no. 2 Seat hinge cover lh
Fully tilt the seatback forward.
Attach the 2 claws and clip.
Pull the hinge cover in the direction indicated by the
arrow ...
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed in the table below and proceed to the page given.
Hint:
*1: "Comes on" means the malfunction indicator lamp
(mil) illuminates.
*2: "Dtc stored" means the ecm memorizes the
malfunction code if the ecm ...
