Toyota RAV4 (XA40) 2013-2018 Service Manual: Repair
- Repair valve seats
- If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
- If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.
Standard width 
- Lap the valve and valve seat by hand with an abrasive compound.
- Recheck the valve seating position.
Other materials:
Installation
Install rear differential support
Install the differential support to the differential
carrier with the 4 bolts.
Torque: 98 n*m (999 kgf*cm, 72 ft.*Lbf)
Install rear differential no. 1 And no. 2 Support
Install the differential no. 1 And no. 2 Supports with
the 4 bo ...
Front suspension lower no. 1 Arm
Components
Removal
Remove front wheel
Remove hood sub-assembly
Remove the hood (see page ed-4).
Suspend engine assembly
Install the no. 1 And no. 2 Engine hangers with the
bolts as shown in the illustration.
Torque: 38 n*m (387 kgf*cm, 28 ft.*Lbf)
parts no.
...
Mass or volume air flow circuit
Description
The mass air flow (maf) meter is a sensor that measures the amount of air
flowing through the throttle
valve.
The ecm uses this information to determine the fuel injection time and to
provide the appropriate air-fuel
ratio.
Inside the maf meter, there is a heated platinu ...
