Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Occupant classification system

Tc and cg terminal circuit
Description Dtc output mode is set by connecting terminals tc and cg of the dlc3. The dtcs are displayed by blinking the srs warning light. Hint: Make sure that dtc b1281 has not been output. ...

Precaution
Inspection procedure for vehicle involved in accident Perform the zero point calibration and sensitivity check if any of the following conditions apply. The occupant classification ...

Other materials:

Terminals of ecu
Check tire pressure warning ecu Disconnect the e56 ecu connector. Measure the voltage and resistance of the wire harness side connector. If the result is not as specified, there may be a malfunction on the wire harness side. Reconnect the e56 ecu connector. Measure the ...

Master cylinder pressure sensor malfunction
Description The master cylinder pressure sensor is connected to the skid control ecu in the abs and traction actuator. Dtc c1281/81 can be detected when the master cylinder pressure sensor sends a master cylinder pressure signal or test mode ends. Dtc c1281/81 is output only in test mo ...

Outside vehicle
General maintenance Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not requ ...

В© 2011-2026 Copyright www.trav4.net