A description of the main areas of each circuit inspection is below.
| Item | Description |
| description | The major role, operation of the circuit and its component parts are explained. |
| Dtc no., Dtc detection condition, trouble area | Indicates the diagnostic trouble codes, diagnostic trouble code detection conditions, and trouble areas of a problem. |
| Wiring diagram | This shows a wiring diagram of the circuit.
Use this diagram together with electrical wiring diagram to thoroughly understand the circuit. |
| Inspection procedures | Use the inspection procedures to determine if the circuit is normal or abnormal. If abnormal, use the inspection procedures to determine whether the problem is located in the sensors, actuators, wire harnesses or ecu. |
| Inspection procedure connector illustrations |
|
Problem symptoms tableRemoval
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery terminal
Notice:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and se ...
Function summary
The following operations can be performed simply by carrying the
electronic key on your person, for example in your pocket. (The driver
should always carry the electronic key.)
Locks and unlocks the side doors
Locks and unlocks the back door
Starts the engine
Operation signals
A bu ...
Console box
Lift the lid while pulling up the
lever to release the lock.
When using the console box lid as an armrest (vehicles with slide
function)
Slide the console box lid forward as
needed. Pull the lid forward by holding the
front of the lid.
Caution
Console box adjustment precaution
D ...