Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

Hint:

Toyota RAV4. Installation


  1. Install rear door belt moulding assembly lh

  1. Attach the claws to install the moulding.

Hint:

Confirm that the moulding is firmly installed.

  1. Install rear door trim board subassembly lh (see page ed-53)

  2. Install rear door armrest base panel upper lh (see page ed-54)

  3. Connect cable to negative battery terminal

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 ...

Front pillar upper cover
Components ...

Other materials:

Checking the battery
Check the battery as follows. â–  Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. Terminals Hold-down clamp â– Before recharging When recharging, the battery produces hydrogen gas which is flammable and exp ...

Diagnostic trouble code chart
Hint: Parameters listed in the chart may be different than your readings depending on the type of instrument and other factors. If any dtcs are displayed during a check mode dtc check, check the circuit for the dtcs listed in the table below. For details of each dtc, refer to the page indica ...

Fail-safe chart
Fail-safe function When communication fails in any of the main wires (communication lines) due to a short circuit or other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning. The table below shows the effects on e ...

© 2011-2026 Copyright www.trav4.net