Make sure that all occupants are wearing their seat belts before driving the vehicle.
Adjusting the mirrors
Correct use of the seat beltsCheck and replace ecu
Notice:
The connector should not be disconnected from
the ecu. Perform the inspection from the
backside of the connector on the wire harness
side.
When no measuring condition is specified,
perform the inspection with the engine stopped
and the ignition switch on.
Check that the con ...
Rear seat outer belt assembly
Components
...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the supplemental
restraint system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage*
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
...