Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Driving procedures

Dinghy towing
Your vehicle is not designed to be dinghy towed (with 4 wheels on the ground) behind a motor home. Notice To avoid serious damage to your vehicle Do not tow your vehicle with 4 wheels on the grou ...

Engine (ignition) switch (vehicles without a smart key system)
Starting the engine Check that the parking brake is set. Check that the shift lever is set in p. Firmly depress the brake pedal. Turn the engine switch to the “start� position to start t ...

Other materials:

Front lower ball joint
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove front wheel Remove front speed sensor lh (for 2wd) (see page bc-191) Remove front brake cylinder assembly lh (see page br-40) Remove front ...

Transmission control cable assembly
Replacement Remove rear console box sub-assembly Remove the console box (see page ip-20). Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pre ...

Installation
Install mass air flow meter Install the mass air flow meter with the 2 screws. Notice: Make sure that the o-ring is not cracked or jammed when installing it. Connect the mass air flow meter connector. Connect cable to battery negative terminal ...

© 2011-2026 Copyright www.trav4.net