Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Check for intermittent problems

Hint:

Inspect the vehicle's ecm using check mode. Intermittent problems are easier to detect with the intelligent tester when the ecm is in check mode. In check mode, the ecm uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

  1. Clear the dtcs (see page es-35).
  2. Switch the ecm from normal mode to check mode using the intelligent tester (see page es-38).
  3. Perform a simulation test.
  4. Check and wiggle the harness(es), connector(s) and terminal(s).
How to proceed with troubleshooting
Hint: *: Use the intelligent tester. Hint: If the display indicates a communication fault in the tester, inspect the dlc3. Hint: Record or print dtcs and freeze frame data, if necessary. ...

Basic inspection
When a malfunction is not confirmed by the dtc check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic ...

Other materials:

Transmission control cable assembly
Replacement Remove rear console box sub-assembly Remove the console box (see page ip-20). Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pre ...

Changing settings of the pre-collision system
â–  Enabling/disabling the pre-collision system The pre-collision system can be enabled/disabled on the screen of the multi-information display. The system is automatically enabled each time the engine switch is turned to ON. If the system is disabled, the PCS warning light will turn on and a mes ...

Fuel pump control circuit
Description When the engine is cranked, the starter relay drive signal output from the star terminal of the ecm is input into the sta terminal of the ecm, and ne signal generated by the crankshaft position sensor is also input into the ne+ terminal. Thus, the ecm interprets that the engine is ...

© 2011-2026 Copyright www.trav4.net