Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

  1. Install mass air flow meter

  1. Install the mass air flow meter with the 2 screws.

Notice:

Make sure that the o-ring is not cracked or jammed when installing it.

  1. Connect the mass air flow meter connector.
  1. Connect cable to battery negative terminal

Toyota RAV4. Installation


Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensi ...

Camshaft timing oil control valve assembly
Components ...

Other materials:

Engine immobilizer system
The vehicle's keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle's on-board computer. Never leave the keys inside the vehicle when you leave the vehicle. This system is designed to help prevent vehicle theft but does ...

Hazard warning switch
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove no. 1 Instrument cluster finish panel cente ...

Driver side seat belt warning light does not operate
Description When the ignition switch is on, the center airbag sensor transmits front seat inner belt status signals to the combination meter through the can bus line. If the driver seat belt is not fastened, the combination meter blinks the driver side seat belt warning light. If the seat bel ...

В© 2011-2026 Copyright www.trav4.net