Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

Hint:

  1. Remove roof drip side finish moulding lh

  1. Remove the 2 roof drip moulding joint covers from the vehicle body.
  2. Remove the roof drip side finish moulding and no. 2 Center roof drip side finish moulding.

Toyota RAV4. Remove roof drip side finish moulding lh


Notice:

Roof drip side finish moulding
Components ...

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. When replacing the clip, heat the clip and body using a heat light. Standard he ...

Other materials:

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor monitors (active air-fuel ratio control type)
Preconditions The monitor will not run unless: 2 Minutes or more have elapsed since the engine was started. The engine coolant temperature (ect) is 75°c (167°f) or more. Cumulative driving time at a vehicle speed of 48 km/h (30 mph) or more exceeds 6 minutes. Air-fuel rat ...

Indicators
The indicators inform the driver of the operating state of the vehicle's various systems. Turn signal indicator Headlight indicator Tail light indicator Headlight high beam indicator Automatic High Beam indicator Fog light indicator (if equipped) Smart key system indicator* 1 Cruise control ...

Installation
Install water pump assembly Remove any old seal packing material from the contact surface. Apply a continuous line of seal packing as shown in the illustration. Seal packing: toyota genuine seal parking black, three bond 1207b or equivalent Standard seal diameter: 2.2 To 2. ...

© 2011-2026 Copyright www.trav4.net