Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal and installation of fuel control parts

Toyota RAV4 (XA40) 2013-2018 Service Manual / Introduction / Repair instruction / Precaution / Removal and installation of fuel control parts

  1. Place for removing and installing fuel system parts
  1. Work in a location with good air ventilation that does not have welders, grinders, drills, electric motors, stoves, or any other ignition sources.
  2. Never work in a pit or near a pit as vaporized fuel will collect in those places.
  1. Removing and installing fuel system parts
  1. Prepare a fire extinguisher before starting the operation.
  2. To prevent static electricity, install a ground wire to the fuel changer, vehicle and fuel tank, and do not spray the surrounding area with water. Be careful when performing work in this area, as the work surface will become slippery. Do not clean up gasoline spills with water, as this may cause the gasoline to spread, and possibly create a fire hazard.
  3. Avoid using electric motors, working lights and other electric equipment that can cause sparks or high temperatures.
  4. Avoid using iron hammers as they may create sparks.
  5. Dispose of fuel-contaminated cloth separately using a fire resistant container.
Electronic control
Removal and installation of battery terminal Notice: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. Be ...

Removal and installation of engine intake parts
If any metal particles enter inlet system parts, they may damage the engine. When removing and installing inlet system parts, cover the openings of the removed parts and engine openings ...

Other materials:

License plate light assembly
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove back door center garnish (see page ed-59) ...

Camshaft position sensor "a" circuit (bank 1 or single sensor)
Description The camshaft position (cmp) sensor consists of a magnet and an iron core which is wrapped with copper wire, and is installed onto the cylinder head. When the camshaft rotates, each of 3 teeth on the camshaft passes through the cmp sensor. This activates the internal magnet in ...

Precaution
Notice: Perform the reset memory procedures (a/t initialization) when replacing the automatic transaxle assembly, engine assembly or ecm (see page ax-18). Hint: Reset memory cannot be completed by only reconnecting the cable to the negative (-) battery terminal. Caution: When using compresse ...

В© 2011-2026 Copyright www.trav4.net