Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: When trouble arises

Light bulbs
You may replace the following bulbs by yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your toyota deal ...

Essential information
...

Other materials:

For vehicles equipped with vehicle stability (vsc) system
Notices when using drum tester Before beginning testing, disable the vsc. To disable the vsc, turn the ignition switch off and connect sst to terminals 12 (ts) and 4 (cg) of the dlc3. Sst 09843-18040 Notice: Confirm that the vsc warning light blinks. Vsc system will be r ...

Vehicle speed signal error (test mode dtc)
Description The tire pressure warning ecu receives a speed signal from the combination meter. This dtc is stored upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The dtc is output only in test mode. Wiring diagram ...

Terminals of ecu
Check transponder key amplifier Disconnect the e5 amplifier connector. Measure the resistance of the wire harness side connector. If the result is not as specified, there may be a malfunction in the wire harness. Reconnect the e5 amplifier connector. Measure the resist ...

В© 2011-2026 Copyright www.trav4.net