Toyota RAV4 (XA40) 2013-2018 Service Manual: Reassembly
Hint:
When installing the ornament plate and emblem, heat the radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the emblem base and emblem excessively.
- Install radiator grille emblem
- Attach the 4 claws to install the radiator grille.
- Install radiator grille ornament plate (for separate type)
- Install the ornament plate with the 12 screws.
- Install hood to radiator grille seal
- Install the new double-side tape.
- Attach the 7 clips and install the hood to radiator grille seal.
Installation
- Install no. 2 Radiator grille lower (see page et-9)
- Install no. 1 Radiator grille lower (see page et-9)
- Install radiator grille (see page et-10)
Disassembly
Hint:
When removing the ornament plate and emblem, heat the
radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the emblem base and e ...
Ebxotdeyrior radiator grille (for 2gr-fe)
Components
...
Other materials:
Knock sensor 1 circuit
Description
Flat type knock sensors (non-resonant type) have structures that can detect
vibrations over a wide band
of frequencies: between approximately 6 khz and 15 khz.
A knock sensor is fitted onto the engine block to detect engine knocking.
The knock sensor contains a piezoelectri ...
Open in one side of can branch line
Description
If 2 or more ecus and/or sensors do not appear on the intelligent tester's
"bus check" screen via the
can vim, one side of the can branch wire may be open. (One side of the canh
[branch wire] /canl
[branch wire] of the ecu and/or sensor is open.)
Wiring diagram
...
Check for open circuit
For an open circuit in the wire harness in fig. 1,
Check the resistance or voltage, as described below.
Check the resistance.
Disconnect connectors a and c, and measure
the resistance between them.
Standard resistance (fig. 2)
Hint:
Measure the resistance while lightly s ...
