Toyota RAV4 (XA40) 2013-2018 Service Manual: Suspension
- Suspension system
- Front wheel alignment
- Rear wheel alignment
- Front shock absorber with coil spring
- Suspension & axle front shock absorber with coil spring (for sport package)
- Front suspension lower no. 1 Arm
- Front lower ball joint
- Front stabilizer bar
- Rear coil spring
- Rear shock absorber
- Rear upper control arm
- Rear no. 1 Suspension arm
- Rear no. 2 Suspension arm
- Suspension & axle rear stabilizer bar
Lower instrument panel
Precaution
Precaution for vehicle with srs airbag and
seat belt pretensioner
Some operations in this section may affect the srs
airbags and seat belt pretensioner. Prior to
performing ...
Suspension system
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected ...
Other materials:
Camshaft position sensor "a" circuit (bank 1 or single sensor)
Description
The camshaft position (cmp) sensor consists of a magnet and an iron core
which is wrapped with copper
wire, and is installed onto the cylinder head. When the camshaft rotates, each
of 3 teeth on the camshaft
passes through the cmp sensor. This activates the internal magnet in ...
Valve body assembly
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove no. 1 Engine under cover
Drain automati ...
Parts location
System diagram
System description
Cruise control system
This system is controlled by the ecm, and is activated by
the throttle position sensor and motor. The ecm controls
the following functions: on-off, set / coast,
resume / accel, cancel, vehicle speed operation,
motor ...
