Toyota RAV4 (XA40) 2013-2018 Service Manual: Air conditioning system (for automatic air conditioning system)
- Precaution
- Parts location (2005/11-2006/01)
- Parts location (2006/01- )
- System diagram
- System description
- How to proceed with troubleshooting (2005/11-2006/01)
- How to proceed with troubleshooting (2006/01- )
- Customize parameters
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu (2005/11-2006/01)
- Terminals of ecu (2006/01- )
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test (2005/11-2006/01)
- Data list / active test (2006/01- )
- Diagnostic trouble code chart (2005/11-2006/01)
- Diagnostic trouble code chart (2006/01- )
Air conditioning
...
Precaution
If any of following conditions are met,
keep engine idling with a/c on (engine
speed at less than 2000 rpm) for at least 1
minute:
Refrigerant gas has been refilled or a/c parts have
...
Other materials:
Transponder chip malfunction
Description
This dtc is output when: 1) during key code registration, a key malfunction
occurs; 2) the key code was
unable to be registered properly.
Inspection procedure
Reregister key
Clear the dtc (see page ei-18).
Reregister the key code with the transponder key ecu
(s ...
Driver side seat belt buckle switch circuit malfunction
Description
The driver side seat belt buckle switch circuit consists of the center airbag
sensor and the front seat inner
belt lh.
Dtc b1655/37 is recorded when a malfunction is detected in the driver side seat
belt buckle switch circuit.
Wiring diagram
Inspection procedure
...
Ig2 relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove ig2 relay
Remove the no. 1 Engine room re ...
