Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Driver profiles- Renaming a driver profile

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals / Controls / Personal settings / Driver profiles- Renaming a driver profile

  1. Countries in which ConnectedDrive is not available: The name that was assigned when the driver profile was set up can be changed via iDrive:
  2. "CAR"
  3. "Driver profiles" As an alternative for Steps 1 and 2, the profile image can be tapped in the top status bar.
  4.  Select driver profile.
  5. "Settings"
  6. Enter a profile name.
  7. Select the symbol.

Selecting a profile picture

Countries in which ConnectedDrive is available: The profile image is transferred from the ConnectedDrive customer portal or the BMW Connected app.

Countries in which ConnectedDrive is not available: Via iDrive:

  1. "CAR"
  2. "Driver profiles"
  3. Move the Controller to the right.

    As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.

  4. "Avatar"
  5. Select the desired profile picture.

Deleting the driver profile

Via iDrive:

  1. "CAR"
  2. "Driver profiles"
  3. Move the Controller to the right.

    As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.

  4. "Settings"
  5. "Remove driver profile"
  6. Select the desired driver profile.
  7. "Delete now"

ConnectedDrive countries: If the driver profile was synchronized with a ConnectedDrive account, the stored data in the ConnectedDrive account will be retained.

System limits

A clear detection of the desired vehicle key may not be possible in the following cases, e.g.:

ConnectedDrive countries: A driver profile can only be created and synchronized with the ConnectedDrive account when cellular network reception is available.

The use of personal settings that are stored in the ConnectedDrive account in other vehicles is subject to technical limitations. For example, settings may be stored for a system that is not available, or available in a non-compatible version, in other vehicles.

Driver profiles- Setting up a PIN
A driver profile with recognition cannot be activated without vehicle key. In this case, a PIN can be set up to activate the driver profile. Non-ConnectedDrive countries: If a PIN was not set up or t ...

Connections
...

Other materials:

Diagnosis system
Description Power door lock control system data can be read in the data link connector 3 (dlc3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs. Check dlc3 The ecu uses iso 15765-4 for communi ...

Intermediate shaft speed sensor "A"
Description This sensor detects the rotation speed of the counter gear. By comparing the counter gear speed signal (nc) with the direct clutch speed sensor signal (nt), the ecm detects the shift timing of the gears and approximately controls the engine torque and hydraulic pressure accord ...

Tc and cg terminal circuit
Description Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light. Wiring diagram Inspection procedure Check dlc3 (tc voltage) Turn the ignition switch on. Measure the voltage of the dlc3. Standar ...

В© 2011-2022 Copyright www.trav4.net