Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual

Toyota RAV4 (XA40) 2013-2018 Service Manual

Srs airbag instructions for canadian owners (in french)
The following is a french explanation of srs airbag instructions extracted from the srs airbag section in this manual. See the srs airbag section for more detailed srs airbag instructions in englis ...

Introduction
...

Other materials:

Torque converter clutch solenoid circuit
Description The shift solenoid valve dsl is turned on and off by signals from the ecm to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch. Fail-safe function: if the ecm detects a malfunction, it turns the shift sol ...

Tc and cg terminal circuit
Description Connecting terminals tc and cg of the dlc3 causes the skid control ecu to display 2-digit dtcs by flashing the abs warning light. Wiring diagram Inspection procedure Check dlc3 (tc voltage) Turn the ignition switch on. Measure the voltage of the dlc3. Standar ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and ...

В© 2011-2026 Copyright www.trav4.net