Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Glass sunroof- Jam protection system

Concept

The jam protection prevents objects or body parts from becoming jammed between the roof and glass sunroof while the glass sunroof is closing.

General information

If a resistance or blockage is detected while the glass sunroof is closing, the closing operation is interrupted once the roof reaches the half-open position, or it is stopped when closing from the tilted position.

Closing from the open position without jam protection

In case of danger from the outside or if ice might prevent normal closing, proceed as follows:


  1. Close all doors.
  2. Push the switch forward past the resistance point and hold.

    The glass sunroof closes with limited jam protection. If the closing force exceeds a specific threshold, closing is interrupted.

  3. Push the switch forward again past the resistance point and hold until the glass sunroof closes without jam protection. Make sure that the closing area is clear.

Closing from the lifted position without jam protection

In case of danger from the outside or if ice might prevent normal closing, proceed as follows:


  1. Close all doors.
  2. Push the switch forward past the resistance point and hold.

Initializing after a power interruption

General information

After a power failure during the opening or closing process, the glass sunroof can only be operated to a limited extent. Initializing the system can help in this case.

The system can be initialized under the following conditions:

During initialization, the glass sunroof closes without jam protection.

Make sure that the closing area is clear.

Initializing the system

Press the switch up and hold it
until the initialization is complete:

Initialization begins within 15 seconds.

Initialization is complete once the glass sunroof and sun protection have opened then closed again.

Glass sunroof- Functional requirements
The glass sunroof and the sun protection can be operated under the following conditions. Standby state is switched on. Drive-ready state is switched on. The vehicle key must be in the car's interi ...

Seats, mirrors, and steering wheel
...

Other materials:

Wireless remote control/electronic key battery
Replace the battery with a new one if it is depleted. You will need the following items: Flathead screwdriver Small flathead screwdriver Lithium battery cr2016 (vehicles without a smart key system), or cr2032 (vehicles with a smart key system) Replacing the battery Vehicles without a ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and ...

Driving the vehicle
The following procedures should be observed to ensure safe driving: Starting the engine Driving With the brake pedal depressed, shift the shift lever to d. Release the parking brake. Gradually release the brake pedal and gently depress the accelerator pedal to accelerate the vehicle. ...

© 2011-2022 Copyright www.trav4.net