Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Laser high beams

Concept

The range of the high beams is increased and ensures an even better illumination of the road.

General information

When the high beams are switched-on, starting with a speed of approx. 37 mph/60 km/h, the laser high beams in the headlight are automatically switched on in addition to the LED high beams.

Depending on the country variant, further information can be obtained from the laser label on the headlight.

Safety information

Safety information


The label is in the headlight and is visible from the outside.

Instrument lighting

Functional requirement

The parking lights or low beams must be switched on to adjust the brightness.

Adjusting

Adjust the brightness with the
thumbwheel.

Interior lights

General information

Depending on the equipment version, interior lights, footwell lights, entry lights, ambient lighting, and speaker lighting are automatically controlled.

Overview

Buttons in the vehicle

Buttons in the vehicle


Interior lights


Reading lights


Switching the interior lights on/off

Press the button.


To switch off permanently: press the button and hold for approx. 3 seconds.

The interior lights in the rear of the vehicle can be switched on and off independently. The button is located in the rear roofliner.

Switching the reading lights on/off

Press the button.


Depending on the vehicle equipment, the reading lights are located next to the interior lights in the front and rear.

High-beam Assistant
Concept The high-beam Assistant detects other traffic participants early on and automatically switches the high beams on or off depending on the traffic situation. General information The high-beam As ...

Ambient light
General information Depending on the equipment version, lighting can be adjusted for some lights in the car's interior. Switching on/off The ambient light is switched on when the vehicle is unlocked, ...

Other materials:

Fuel pump control circuit
Description When the engine is cranked, the starter relay drive signal output from the star terminal of the ecm is input into the sta terminal of the ecm, and ne signal generated by the crankshaft position sensor is also input into the ne+ terminal. Thus, the ecm interprets that the engine is ...

Diagnosis system
Description Power door lock control system data can be read in the data link connector 3 (dlc3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs. Check dlc3 The ecu uses iso 15765-4 for communi ...

Sockets
Concept The lighter socket can be used as a socket for electrical equipment when standby and driveready state are switched on. General information The total load of all sockets must not exceed 140 watts at 12 volts. Do not damage the socket by using non-compatible connectors. Safety information Wa ...

В© 2011-2022 Copyright www.trav4.net